Security measures and the general rules accepted at service of components of fuel paths of internal combustion engines

At service of components of a fuel path it is necessary to adhere to the following general rules:

Do not come nearer to works place with open fire, do not smoke and do not turn on any heating devices! Always keep in readiness the fire extinguisher; Fuel evaporations are toxic, - make power supply system service in well ventilated room; Remember that the fuel path of system of injection constantly is under pressure, - at an otpuskaniye of shtutserny sockets fuel can escape from the line under pressure! Do not forget to put on the goggles, the spilled fuel immediately collect rags; Keep in mind that pressure of fuel at an exit in the diesel engine makes about 1100 atm of nozzles, - do not allow hit of any parts of a body under a fuel stream; Collars of tape and tightening type can be applied to fastening of shlangovy connections of a fuel path. After a detachment of hoses it is necessary to replace tightening collars tape or worm. Fixing of locks of some collars demands use of special adaptations, - consult with experts firm HUNDRED KIA. Before removing any components of a fuel path carefully wipe their surfaces in places of interface to the purpose of prevention of internal pollution of system; The removed components stack on a pure lining and cover with polyethylene, paper, or НЕВОРСЯЩЕЙСЯ rags; Do not forget to cork the open ends of the disunited shtutserny sockets of a fuel path, whenever possible using for this purpose special caps; Special attention give to purity observance, - carefully wipe and degrease all established components, replaceable details take from packing only directly ahead of installation; Avoid application of the compressed air at the opened fuel system, whenever possible try not to move the car; Do not apply to sealing of joints of components hermetics containing silicone, - hit in the engine of particles of poorly combustible silicone is interfaced to risk of failure a lambda probes; Before removal of a fuel tank merge from it all fuel, - in case of need use for fuel pumping out by the special pump; Before a detachment of assembly tapes of fastening of a fuel tank at removal of the last prop up it from below a telezhechny jack through wooden laying; Remember that the emptied fuel tank is potentially explosive and before utilization should be without fail cut on a part, - take measures against an iskroobrazovaniye when using the cutting tool; After installation of a fuel tank on the car start the engine and check tightness of the corresponding connections.