|
|
Kia Sportage>> Brake system
Brake system
Specifications
|
|
Separate characteristics are provided also in the text of head and in case of obligation of their performance are allocated with a bold print. |
General data
System type
|
|
Hydraulic, double-circuit, with the vacuum amplifier and a dynamic regulator brake force |
|
|
Hydraulic, double-circuit, with the vacuum amplifier and electronic and hydraulic adjustment of brake forces |
Type and volume of hydraulic liquid
|
see. Specifications to Head the Current leaving and service
|
Brake mechanisms
|
Forward wheels |
| Type |
Disk, ventilated |
| Thickness of frictional overlays of blocks, mm |
|
|
11 |
Limiting admissible value
|
2.0 |
| Thickness of brake disks, mm |
|
|
24.0 |
Limiting admissible value
|
22.4 |
| Limiting admissible size of lateral palpation, mm |
0.1 |
|
Back wheels |
| Type |
The drum-type |
| Maximum admissible diameter of a brake drum, mm |
251.2 |
| Minimum admissible thickness of frictional overlays of boots, mm |
1.5 |
| Limiting admissible size люфта landings of bashmachny assemblies in drums (see. Section Service of drum-type brake mechanisms of back wheels), mm |
Data are absent |
Parking brake
| Drive type |
Manual, hummock with an exit to brake mechanisms of back wheels |
| Number of clicks of a ratchet when raising the driving lever with effort of 10 kgfs |
6 ÷ 8 |
Regulator of brake forces
| Target pressure of a regulator (approximately), kgf/cm2
|
At entrance pressure of 32 kgfs/cm2
|
30 ÷ 32 |
At entrance pressure of 100 kgfs/cm2
|
52 ÷ 63 |
Pedal of a foot brake
Vacuum amplifier of brakes
See. Section Check of serviceability of functioning of the vacuum amplifier of brakes.
ABS/EBD
| Size of working gaps of wheel ABS sensors, mm |
|
|
|
0.3 ÷ 1.0 |
|
|
0.5 ÷ 1.0 |
| Resistance of wheel sensors, Ohm |
|
|
1385 ± 110 |
|
|
1000 ± 50 |
Codes of malfunction of ABS/EBD
|
DTC
|
Possible source of refusal
|
Possible reason |
| С1101 |
Excessively (> 17 In) tension of the battery |
The corresponding electroconducting is faulty;
HECU is faulty |
| С1102 |
There is not enough (<9.4 In) tension of the battery | The corresponding electroconducting is faulty;
HECU is faulty |
| С1200, С1203, С1206 |
Chain corresponding (left forward/right forward/back) the wheel sensor |
Break, or short circuit on weight;
The sensor is faulty;
HECU is faulty |
| С1201, С1204, С1207 |
Non-standard signal corresponding (left forward/right forward/back) the wheel sensor |
It is incorrectly established, or the corresponding sensor is faulty;
The sensor rotor, or the wheel bearing (forward wheels) is faulty;
HECU is faulty |
| С1202, С1205, С1208 |
There is no signal from corresponding (left forward/right forward/back) the wheel sensor |
It is incorrectly established, or the corresponding sensor is faulty;
The sensor rotor is faulty;
HECU is faulty |
| С1274, С1275 |
Alarm line of the sensor of overloads (G) |
Electroconducting break between the sensor G and HECU;
The sensor G is faulty;
HECU is faulty |
| С1604 |
HECU chain |
Violation on a chain site between HECU and Ý/m the valve;
HECU is faulty |
| С2112 |
Klapannoye relay or safety lock |
The klapanny relay is faulty;
Connecting electroconducting is faulty;
HECU is faulty;
The hydromodulator is faulty |
| С2402 |
Electromotor chain |
Break or short circuit in a chain of the electromotor or its relay (including a safety lock);
HECU is faulty;
The hydromodulator is faulty |
Efforts of a tightening of carving connections, Hм
|
|
Efforts of a tightening of separate elements of fixture can be brought directly in the text of sections where they are allocated with a bold print. |
| Wheel bolts |
98 |
| Lock-nut of the D rod of a pusher of the vacuum amplifier (see an illustration an illustration) |
23.5 ÷ 34.3 |
| Lock-nut In the sensor switch of stoplights (see an illustration) |
13.7 ÷ 17.7 |
| Axial nuts of a pedal of a foot brake |
27 |
| Nuts of fastening of a basic arm of a regulator of brake forces |
9.8 ÷ 16 |
| Bolt of fastening of a regulator of brake forces |
22.6 ÷ 42.2 |
| Nuts of shtutserny sockets of a regulator of brake forces |
12.8 ÷ 21.6 |
| Lock bolt of GTTs |
2.0 ÷ 2.5 |
| Screw of fastening of the tank of brake liquid |
1.0 ÷ 1.5 |
| Nuts of the GTTs shtutserny sockets |
13 ÷ 22 |
| Nuts of fastening of the vacuum amplifier of brakes |
16 ÷ 23 |
| Nuts of shtutserny sockets of a joint of flexible hoses with tubes of brake lines |
8 ÷ 12 |
| Bolts of fastening of supports of brake mechanisms of forward wheels |
88 ÷ 108 |
| Hollow bolts of shtutserny connections of supports |
22 ÷ 29 |
| Directing bolts of supports of brake mechanisms of forward wheels |
22 ÷ 34 |
| Bolts of fastening of wheel cylinders to boards of brake mechanisms of back wheels |
8 ÷ 18 |
| Nuts of fastening of boards of brake mechanisms of back wheels |
98 |
| Bolts of fastening of ECU to HCU |
|
|
1.3 ÷ 1.4 |
|
|
1.7 ÷ 1.9 |
| Adjusting pin of HECU |
5.8 ÷ 7.2 |
| Nuts of shtutserny HCU sockets |
9.4 ÷ 15.9 |
| Bolts of fastening of wheel sensors |
9.5 |
|
|