Kia Sportage>>
Suspension bracket and steering>>
Suspension bracket geometry>>
Check and adjustment of corners of installation of forward wheels
Check and adjustment of corners of installation of forward wheels
Make sure of performance of all necessary conditions (see. Section suspension bracket Geometry).
Disorder and выбег
Check
|
|
Check of geometrical parameters of a suspension bracket should be made at the special stand in the conditions of a car-care center workshop. |
|
|
Tire out the car forward wheels on rotary circles of in a special way equipped stand.
Remove stupichny couplings of a free wheeling.
Connect a measuring instrument and make necessary measurements. Compare results of measurement to requirements of Specifications of Head the Suspension bracket and a steering, in case of need make the corresponding adjustments.
|
|
Adjustment
Adjustment of disorder is made by a simultaneous povorachivaniye in one direction (to from the plane of symmetry of the car, or outside) and on an identical corner of ekstsentrikovy shpindelny bolts of fastening to a frame of the top levers of a suspension bracket. Each division of the scale put on a flange of a head of a bolt corresponds to disorder change on 0.4 °, - as a basic label the vertical risks put on a surface of basic arms of levers are used.
The size выбега is corrected by a simultaneous povorachivaniye of the same bolts, but in opposite directions (one to the plane of symmetry of the car, the second - outside). Thus the step of adjustment makes 0.55 ° on one division of a scale.
Convergence
Check
|
|
Tire out the car on an equal horizontal platform with a firm covering and bring forward wheels into rectilinear situation.
|
|
By means of a measuring bar define size of convergence of wheels. Compare result of measurement to requirements of Specifications of Head the Suspension bracket and a steering, in case of need make the corresponding adjustment.
|
|
|
Adjustment
|
|
Release lock-nuts of tips of both steering drafts.
|
|
Adjust convergence of forward wheels by a povorachivaniye on an identical corner and in one direction of both tips.
|
Do not forget to tighten a lock-nut with demanded effort (88 ÷ 118 Nanometer).
|
|