KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
   System of ignition of the petrol engine
      General information, security measures
      Checks of a control system by ignition
      Check of a corner of an advancing of ignition
      Check of coils of ignition
      Check of a condition of VV of electroconducting
      Check of the sensor of a detonation
      Replacement of coils of ignition
      Spark plugs - the general information
      Removal and installation of the sensor of provision of a camshaft (CMP)
      Removal and installation of the sensor of provision of a cranked shaft (CKP)
      Removal and installation of the sensor of a detonation (KS)
   System of simplification of cold start of the diesel engine
   Charge and start systems
Five-step manual box of gear shifting
Automatic transmission
Transmission line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections



Kia Sportage>> Systems of electric equipment of the engine>> System of ignition of the petrol engine>> Check of coils of ignition

Check of coils of ignition

Coils of ignition are located under a service cover from the top party of the power unit under a sleeve of an inlet air path of the engine.

1 — ignition Coils
2 — the Inlet air line
3 — the Service cover

Tension check

 PERFORMANCE ORDER

  1. Make sure that ignition is switched off.
  2. Remove a service cover and disunite the contact socket of the coil of ignition.
  1. Include ignition and measure tension on plugs of white-red wires of the contact socket of the coil, - demanded value makes about 12 Century.
  1. If tension is absent, check a condition of the main safety lock, the switch of ignition and connecting electroconducting of the corresponding contour.
  2. The faulty coil is subject to replacement.

Resistance check

Remember that in each coil it is organized on two primary and on two secondary windings which should be checked in an individual order.


 PERFORMANCE ORDER

  1. Connect an ohmmeter to positive (+) to the plug of the contact socket of the coil, then, serially connecting the second wire of a measuring instrument to the negative (-) to socket plugs, measure resistance of primary windings of bobbin assembly, - demanded value makes 0.45 ÷ 0.55 Ohm at 20 ° Page.
  1. Operating in a similar manner, measure resistance of secondary windings of the coil, - demanded value makes 13 ÷ 15 kiloohms at 20 ° C.
  1. At failure of any of windings bobbin assembly is subject to replacement (see. Section Replacement of coils of ignition).