Kia Sportage>>
Onboard electric equipment>>
Assembly blocks of safety locks/relay - the general information, removal, installation, replacement of safety locks
Assembly blocks of safety locks/relay - the general information, removal, installation, replacement of safety locks
General information
All onboard electroconducting used on considered models can be broken into 13 main plaits conditionally:
Plait of electroconducting of a front
Burn down electroconductings of a combination of devices
Plait of electroconducting of the dashboard
Burn down electroconductings of fuel injectors/nozzles
Plait of electroconducting of the engine
Plait of electroconducting of salon
Plait of electroconducting of a back
Burn down electroconductings of a rear bumper
Burn down electroconductings of the left forward door
Burn down electroconductings of the right forward door
Burn down electroconductings of the left back door
Burn down electroconductings of the right back door
Burn down electroconductings of a door of a back
For protection of onboard consumers of the electric power the safety locks placed in two assembly blocks, one of which - main are used - is located in the right part of the impellent compartment, the second is built in in the dashboard to the left of a steering column and equipped with a folding cover.
Replacement of safety locks
Schemes of an arrangement of safety locks in the assembly are provided in Specifications of Head Onboard electric equipment at the beginning of the present chapter. The label with the scheme of an arrangement of internal components is usually pasted also on a demountable cover of the main assembly block.
|
|
For replacement of the failed safety lock which is located in salon the assembly block, open the plastic cover equipped with loops with «FUSE» inscription in the basis of a forward rack at the left under the dashboard, then by means of the clip fixed in the block take a defective safety lock, - and establish on its place replaceable, calculated on the same current.
|
|
Replacement of safety locks of the main assembly block is made in a similar manner, - try not to drop a demountable cover in an impellent compartment.
|
|
|
Removal and installation of the main assembly block
|
Disconnect a negative wire from the battery.
Previously having marked, disconnect electroconducting and take the assembly block from an impellent compartment.
Installation is made upside-down.
|
|