|
|
|
|
KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning General information System of cooling of the engine Systems of ventilation, heating and air conditioning General information and security measures Diagnostics of malfunctions, check of components of To/in system Removal and installation of assembly of the forcing fan/evaporator, service of components Removal and installation of assembly of a heater, service of components Removal and installation of lines of communication of a refrigerator path of To/in system Removal, check and To/in compressor installation Removal, check and installation of the fan of the To/in condenser Removal, check and To/in condenser installation Removal, check and receiver dehumidifier installation
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
Five-step manual box of gear shifting
Automatic transmission
Transmission line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections
|
|
|
|
Kia Sportage>> Systems of cooling, heating, ventilation and air conditioning>> Systems of ventilation, heating and air conditioning>> Removal, check and installation of the fan of the To/in condenser
Removal, check and installation of the fan of the To/in condenser
Removal
|
|
Ventilyatorny assembly is located ahead of the condenser heat exchanger, at once behind a forward lattice.
Prop up wheels protivootkatny boots.
Disconnect a negative wire from the battery.
Remove three clamps of fastening of the finishing panel to the top section of a forward casing.
Turn out the screw of fastening of a forward lattice to a cowl rack.
Accurately wring out four lock uvulas and remove a forward lattice.
Liberate clamps from lateral sections of a forward casing and latch them on the regular places in a forward lattice.
|
|
Disunite the socket of electroconducting of the fan of the condenser.
|
|
|
Turn out fixing bolts and remove ventilyatorny assembly.
|
|
|
Check
|
|
By means of an ohmmeter make sure available conductivity between plugs of the socket of electroconducting of the fan. If conductivity is absent, replace the driving electromotor.
Submit on electromotor plugs a food 12 In, - if the krylchatka does not start to rotate, replace the electromotor.
|
|
Installation
|
|