KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning
   General information
   System of cooling of the engine
      Cooling liquid - general information
      Replacement of cooling liquid - general comments
      Tightness check, replacement of hoses of system of cooling
      Thermostat check
      Check of serviceability of functioning of the coupling of coupling of the fan of system of cooling
      Washing of a path of system of cooling
      Removal and thermostat installation
      Removal, check of a condition and installation of a radiator of system of cooling, replacement of radiatorny hoses
      Removal and installation of a broad tank
      Removal and installation of a perepuskny branch pipe of an okhladitelny path of the petrol engine
      Replacement of the bearing of a drive of the fan of system of cooling
      Removal, installation and service of the water pump
   Systems of ventilation, heating and air conditioning
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
Five-step manual box of gear shifting
Automatic transmission
Transmission line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections



Kia Sportage>> Systems of cooling, heating, ventilation and air conditioning>> System of cooling of the engine>> Replacement of the bearing of a drive of the fan of system of cooling

Replacement of the bearing of a drive of the fan of system of cooling

 PERFORMANCE ORDER

  1. Remove a belt of a drive of the generator.
  2. Remove a krylchatka of the fan, then dismantle from a landing flange of bearing assembly a pulley of a drive of the fan.
1 — Krylchatka
2 — the Pulley
  1. Release fixture and remove bearing assembly (1) from the engine block.
  1. By means of a special stripper and a suitable drift dismantle on the press a landing flange of a driving pulley.
1 — the Press
2 — the Drift
  1. By means of a cylindrical opravka in external diameter of 20 mm выпрессуйте bearing.
1 — the Press
2 — the Drift
3 — a bearing Shaft
  1. Press a power shaft in a landing flange of a pulley, - the size of a vystupaniye of a pin of a shaft over a face surface of a stupichny part of a flange should make 2.1 mm.
1 — the Flange
2 — a bearing Shaft
3 — the Press
4 — the Drift
5 — the Bearing
6 — the Flange
  1. Having arranged components according to the provided instructions, make a press fitting of the new bearing in the landing nest in a basic arm.
1 — the Drift
2 — the Landing flange
3 — the Bearing
  1. Further installation is made as it should be, the return to an order of dismantle of components, - track observance of requirements of Specifications of the Head of System of cooling, heating, ventilation and air conditioning to efforts of a tightening of carving fixture. Do not forget to adjust effort of a tension of a belt of a drive of the generator.