Washing of a path of system of cooling

On considered models possibility plum of cooling liquid from the block of the engine is not provided.

PERFORMANCE ORDER

Remove a thermostat casing (see. Section Removal and thermostat installation). Take the thermostat, then establish its casing on a regular place, having tightened fixing bolts with demanded effort. Remove protection of a case. Uncover a radiator, then open the drain gate (see an illustration) and lower cooling liquid from a radiator in capacity suitable on volume. Close the drain gate. Remove a broad tank (see. The section Removal and installation of a broad tank) and several times carefully wash out it pure flowing water. Fill in to the okhladitelny highway pure water. Start the engine and warm up it to normal working temperature. In case of need add in a radiator a necessary quantity of water. Open the drain gate and start to merge from system water, at the same time supporting its level by a dolivaniye in a radiator mouth. Continue procedure performance until water following from a radiator does not become pure and transparent. Merge the remained water, close the drain gate. Carefully wash out and establish into place the thermostat. Establish a broad tank. Fill system of cooling with a fresh mix (see. Head Current leaving and service). Establish into place a radiator cover, make sure of lack of signs of development of leakages of cooling liquid, then muffle the engine.