KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
Five-step manual box of gear shifting
Automatic transmission
   General information
   Search of malfunctions - the general information
   Reading of the DTC codes, cleaning of memory of the processor
   Checks and adjustments of components of a control system of AT
   Checks and adjustments of a mekhaniko-hydraulic part
   Check and adjustment of a driving cable of AT
   Removal and installation of the lever of the AT selector
   Removal and AT installation
Transmission line
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections
Kia Sportage>> Automatic transmission>> Reading of the DTC codes, cleaning of memory of the processor

Reading of the DTC codes, cleaning of memory of the processor

Reading of codes

One of the functions which are carried out by the module of management of AT (TCM), continuous problem diagnostics of components of a control system by transmission (information sensors, actuation mechanisms and actually TCM) is. In case of detection of malfunction the module of management fixes a 5-unit diagnostic code (DTC) adhered to the corresponding contour of a control system in the memory. The list of the most typical codes is provided in Specifications of Head Automatic transmission.

For reading written down in memory of the DTC processor the special Hi-Scan Pro scanner (K2CA of 089 HSP), connected to the equipped diagnostic socket located in an impellent compartment folding cover (is used see. Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases).

 PERFORMANCE ORDER

    Connect the scanner, include ignition and, operating according to instructions of manufacturers of the device, poll memory of the TCM processor, - at existence in memory of codes of malfunctions (DTC), make the corresponding regenerative procedures.

In the absence of near at hand scanner reading of codes can be made by means of a control lamp of HOLD: at the switched-off ignition close the plug "n" on the plug of grounding («s») of DLC, then turn a key in the situation ON, - the table of codes of compliance and the chart of a principle of their highlighting are provided in Specifications of Head Automatic transmission.

    In summary make cleaning of memory of TCM, then repeat procedure of reading and make sure that memory of the processor is empty.

Cleaning of memory of the processor

Cleaning of memory of TCM is made by means of the scanner (act according to instructions of manufacturers of the device). Alternatively, it is possible to clear memory by plug "j" short circuit on the plug of grounding («s») of DLC at the included ignition.

 PERFORMANCE ORDER

    In summary make sure that no DTC were brought in memory of the module repeatedly.