KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
Five-step manual box of gear shifting
Automatic transmission
Transmission line
   General information
   Coupling
      General information
      Check and correction of level of hydraulic liquid
      Check and adjustment of a pedal of coupling
      Removal and installation of a pedal of coupling
      Removal, service and installation of the main cylinder of a drive of switching off of coupling
      Removal, service and installation of the executive cylinder of a drive of switching off of coupling
      Removal, check of a condition and installation of components of coupling
   Transfer case
   Driveshafts
   Bridges
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections



Kia Sportage>> Transmission line>> Coupling>> Removal and installation of a pedal of coupling

Removal and installation of a pedal of coupling

Details of installation of a pedal of coupling

1, 4, 11 — Nuts
2, 6 — Bolts
3 — the Returnable spring
4 — the Flat washer
7 — the Remote plug
8 — Axial plugs
9 — the Clamp (is subject to replacement without fail)

10 — the Finger
12 — the Pusher
13 — the Cutting head
14 — the Emphasis
15 — the Pedal
16 — the Overlay of a block


 PERFORMANCE ORDER

  1. Take a clamp and a finger of fastening of a pusher.
  2. Disconnect a returnable spring.
  3. Give a fixing nut, remove a washer and take an axial bolt.
  4. Take remote and two axial plugs.
  5. Estimate degree of wear of axial plugs and an overlay of a block, whether check will bend the lever of a pedal and whether the returnable spring weakened. Replace defective components.
  6. Installation is made as it should be, the return to an order of dismantle of components, - axial and remote plugs before landing grease with lithium greasing (NGLI No. 2). Track observance of requirements of Specifications of Head the Transmission line to efforts of a tightening of carving fixture.
  7. In summary do not forget to adjust a free wheeling of a pedal (see. Section Check and adjustment of a pedal of coupling).