KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
Five-step manual box of gear shifting
Automatic transmission
Transmission line
   General information
   Coupling
   Transfer case
      General information
      Removal and installation of the lever of switching of modes of a transfer case
      Removal and installation of assembly of a drive of a speedometer
      Replacement of epiploons of target shaft
      Removal and installation of a transfer case
   Driveshafts
   Bridges
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections



Kia Sportage>> Transmission line>> Transfer case>> Removal and installation of a transfer case

Removal and installation of a transfer case

Depending on specifics of prospective procedures of service the transfer case can act in film as assembled with transmission, and in an individual order. The description of procedure of removal of a transfer case assembled with transmission is provided in Heads the Five-step manual box of gear shifting and Automatic transmission.


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove levers of switching of the AT RKPP/selector (see. Head the Five-step manual box of gear shifting or Automatic transmission respectively) and a transfer case (see. Section Removal and installation of the lever of switching of modes of a transfer case).
  3. Merge from a transfer case oil (see. Head Current leaving and service).
  4. Remove driveshafts (see. Section Removal, service and installation of driveshafts).

In order to avoid violation of balancing of the driveshaft do not disunite a shlitsevy joint of its sections!

  1. Disconnect electroconducting from the 4WD alarm indicator sensor switch.
  2. Disconnect electroconducting from VSS.
  3. In order to avoid damage of support of a suspension bracket of the power unit prop up transmission by a telezhechny jack.
  4. Turn out fixing bolts (two in a support and two in the chassis) and remove a lateral support of a suspension bracket of a transfer case.
  5. Turn out eight fixing bolts of the chassis, plus four bolts of fastening of the bottom support and remove a cross-section beam.
  6. Prop up a transfer case a telezhechny jack.
  7. Turn out 10 fixing bolts and, slightly obstukivy an interfaced surface a kiyanka, separate a transfer case from transmission.
  8. Lower a transfer case, take it from under the car and transfer on a workbench.
  9. Installation is made upside-down, - track observance of requirements of Specifications of Head the Transmission line to efforts of a tightening of carving fixture. Special attention give to correctness of connection of driveshafts (track correctness of combination of the landing labels put in the course of dismantle).
  10. In summary fill in in a box necessary amount of fresh oil of a demanded grade, correctly having modified its level (see. Head Current leaving and service).