KIA of Sportazh - Kia Sportage
Governing bodies and operation receptions
Current leaving and service
Engine
Systems of cooling, heating, ventilation and air conditioning
Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
Systems of electric equipment of the engine
Five-step manual box of gear shifting
Automatic transmission
Transmission line
Brake system
   General information and security measures
   Checks and adjustments of a pedal of a foot brake
   Check of the lever of the parking brake
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of the differential perepuskny valve regulator of pressure (model without ABS and EBD)
   Removal and installation of a pedal of a foot brake
   Removal, service and installation of the main brake cylinder
   Removal and installation of assembly of the vacuum amplifier of brakes
   Assessment of degree of wear, replacement of blocks of disk brake mechanisms of forward wheels
   Dismantling of the brake mechanism of a forward wheel, assessment of a condition of a disk
   Removal and installation of flexible brake hoses of a hydraulic path of brake mechanisms of forward wheels
   Service of drum-type brake mechanisms of back wheels
   Removal and installation of the lever of the parking brake, adjustment of a driving cable
   Pumping of brakes
   Reading of codes of malfunctions of ABS/EBD, cleaning of memory of the processor
   Removal and installation of hydraulic and electronic ABS/EBD control units
   Removal, check installation of wheel ABS sensors
   Replacement of rotors of ABS sensors of forward wheels
Suspension bracket and steering
Body
Onboard electric equipment
Control body sizes
Schemes of electric connections



Kia Sportage>> Brake system>> Removal and installation of assembly of the vacuum amplifier of brakes

Removal and installation of assembly of the vacuum amplifier of brakes

At removal act as numbering of components.

Order of dismantle of assembly of the vacuum amplifier of brakes

1 — Sockets of electroconducting of the sensor switch of level of brake liquid and the differential sensor switch
2 — the Vacuum hose
3 — Brake lines
4 — the Bolt
5 — the Valve regulator
6, 9 — Nuts

7 — the Basic arm of the valve regulator
8 — ГТЦ
10 — the Clamp
11 — the Finger
12 — the Vacuum amplifier
13 — Sealing laying


 PERFORMANCE ORDER

    Remove GTTs (see. Section Removal, service and installation of the main brake cylinder). Disconnect from assembly of the brake amplifier a vacuum hose.
    In salon of the car remove a clamp and take a finger of fastening of a rod of a pusher to a brake pedal.
    From the back party of a partition of an impellent compartment release four fixing nuts and remove assembly of the vacuum amplifier with GTTs pusher.
    Installation is made upside-down, - track observance of requirements of Specifications of Head Brake system to efforts of a tightening of carving fixture. Do not forget to adjust length of a rod of a pusher (see. The section Removal, service and installation of the main brake cylinder) and to pump over a hydraulic path (see. Section Pumping of brakes)