>> Power supply systems, managements of engine/decrease in toxicity of the fulfilled gases and production of the fulfilled gases
>> Power supply system of petrol engines
>> Removal and installation of the toplivoraspredelitelny highway
Removal and installation of the toplivoraspredelitelny highway
Details of installation of the toplivoraspredelitelny highway
Dump pressure in a power supply system (see. Undressed Sbrasyvaniye pressure in fuel system of the petrol engine, filling of a fuel path).
Merge cooling liquid (see. Head Current leaving and service).
Disconnect a negative wire from the battery.
Turn out two bolts of an air line of an inlet air path.
Release a collar of fastening of shlangovy section of an air line to inlet section of the case of a throttle.
Remove four ventilating hoses connected in an air line.
Disconnect electroconducting from the MAF sensor.
Turn out bolts of fastening of assembly of the MAF sensor.
Release a collar of fastening of an air line to air purifier assembly.
Turn out a bolt of fastening of a basic arm of an air line.
Turn out bolts of fastening of a basic arm of a cable of a drive of butterfly valves.
Disconnect a cable of a drive of butterfly valves.
Remove the vacuum hose going from the inlet pipeline to a vacuum tube.
Disconnect electroconducting from TPS and the IAC valve.
Disconnect two hoses of an okhladitelny path from the throttle case.
Release a fixing collar and disconnect a hose of assembly of the IAC valve.
Release a collar and disconnect a hose from the air distributor.
Release collars and disconnect from the air distributor vacuum hoses of the brake amplifier and темпостата.
Turn out two fixing bolts and remove the air distributor a basic arm.
Turn out the bottom bolt of a basic arm of the IAC valve.
Turn out two top bolts of a basic arm of the inlet pipeline.
Hang out the car over the earth.
Turn out the bottom bolts of a basic arm of the inlet pipeline.
Lower the car on the earth.
Disconnect from a knee an inlet hose of a heater.
Disconnect a vacuum hose from a vacuum tube.
Give three bolts with nuts and remove the air distributor.
Disconnect топливопровод from a pressure regulator.
Disconnect submitting hose from the toplivoraspredelitelny highway.
Turn out two bolts of fastening of the highway.
Remove clamps of fastening of injectors and remove the toplivoraspredelitelny highway.
Remove two injector insulators (see. Section Removal and installation of fuel injectors).
Remove a damper of pulsations of pressure.
Remove a regulator of pressure of fuel (see. Section Removal and installation of a regulator of pressure of fuel).
Carefully smooth out all interfaced surfaces.
Installation is made upside-down. Do not forget to adjust a cable of a drive of a butterfly valve (see. Section Removal and installation of a pedal of gas, adjustment of a cable of a drive of a butterfly valve).
In summary fill cooling system, start the engine and check it on existence of signs of leakages of the corresponding working liquids.