Warm up the engine to normal working temperature.
To Poddomkratta the car also establish it on props, or tire out on a viewing hole/platform.
Get under a drain opening of the pallet of a case capacity in volume about 10 l for collecting the fulfilled oil.
|
Having put on protective rubber gloves, turn out a drain stopper and lower impellent oil in the prepared capacity, correcting situation of the last in process of weakening of a pressure of a stream.
|
Check a condition of the fulfilled oil, - if at it there is metal sawdust, it indicates existence задиров, for example, in bearings of a cranked shaft. For the purpose of an exception of complications after performance of regenerative repair of the engine it is necessary to clean carefully everything маслотоки greasing systems.
|
By means of a special stripper dismantle the oil filter and its sealing ring which can remain stuck to a landing surface of a case.
|
Wipe a surface of a case of the engine interfaced to the filter pure rags.
Slightly grease with pure oil the NEW sealing ring and plant it on the new filter.
|
On petrol models screw oil in a reception opening of the engine so that the sealing ring nestled on an interfaced surface of the block, then hold on it for 420 ° (1 and 1/6 turns). On diesel models tighten the filter against the stop a hand, then hold on it a coupling key on 2/3 turns, the effort of a tightening of the filter should make about 19.6 ÷ 24.5 Nanometers.
|
Having replaced a sealing washer, screw a drain stopper and tighten it with demanded effort (30 ÷ 35 Nanometer).
Fill in the engine fresh oil of a demanded grade (see. Section Check of level of working liquids).
Wait about 5 minutes, then check level of oil and, in case of need, make the corresponding adjustment.
Having made a short trial trip, make sure of lack of signs of development of leakages of oil through a drain stopper of the pallet and a place of a joint of the filter with a case. In case of need tighten leaky planted element, then once again check level of oil and if it is required, make the corresponding adjustment.
|
|